Model printed in PLA and PETG in Creality Print on the standard "Normal" profile. Layer height 0.2, nozzle 0.4, filling 15%. Brim and support disabled.

Pins should be printed separately, Brim and support optional, but not suggested, with 100% filling.

Depending on the printer calibration and the filament used, all three pin lengths should be printed to make installation trouble-free and at the same time ensure proper hold.

The distance between the table and the screen is approximately 1.5mm. The distance between the screen and the head at its maximum position to the right is approximately 2mm.

Thanks to additional brackets, the holder rests on the printer's base, providing a secure and rigid hold.

Printing takes about an hour and uses 20 grams of filament (including all three pairs of pins).

It is suggested to first connect the pins to the screen, then attach the screen to the holder, and then attach the whole thing to the base, using the original screws.