This is a Nativity Scene that I created to be printed flat on the build plate. This layers one over the other to create a scene that can be lit with a tea light or other lighting. The base is a 3x3x2 inch base that will allow most tea lights to be put in easily and latch shut. Each scene is a 6x7inch print that should lay flat and print without supports on the print bed. The entire thing assembles without any glue or fasteners and should sit easily on a flat surface. Layer height can be anything. I would suggest printing the latch at 100% so that it doesn’t break or bend from putting it in and out of the base but that's just a recommendation. If you find anything that needs to be changed or added let me know and I will make modification.