I actually found this model after printing a similar one that had the print in place lever fail. I will use this one in the future.

I only printed the part that broke in the original model. it doesn't quite work as well but at least it doesn't break instantly.

Excellent

Was a fine print. I should have paid attention to the description that said said not to put supports on most of the parts. Strongly recommend printing this! Google translated out of respect of the original designer. 印刷品很精致。我应该注意说明，上面说不要在大多数部件上加支撑。强烈建议打印！ 出于对原设计师的尊重，谷歌进行了翻译。

打印无问题，拆支撑时候需要慢点。

funktioniert prima! sieht sehr süß aus

awesome but the Support on the hook is a littlebit horrible to remove (Not the hook for the Key)

This setup works MUCH better than the model it's based on. I like the idea of using a piece of filament as part of the hinge. Much smoother movement. Thanks for remixing.

Very good midel, but I only printed the functional parts for the tail.