Tablet / Phone Stand
Tablet / Phone Stand
3D
Published 2017-03-21T13:24:25+00:00
This Tablet / Phone stand is a super simple stylish design. The stand was designed to be as small as possible, so it is quick and easy to print as well as not consuming a lot of filament, but adequate to hold most tablets and phones in either orientation.
You can use a tablet or phone in the stand however if it slides around too much on hard surfaces (as plastic can) the base / footprint could easily have thin foam rubber padding added to make it non-slip.
Seven files have been provided to accommodate devices from <7mm thick up to 13mm thick. Just measure the thickness of your tablet or phone and print the file of the next size up..... so a tablet measuring 8.25mm is best in the 9mm stand. This ensures a snug fit. It's easy... but please remember clearance is required so a 10mm thick device will not fit a 10mm stand... print the 11mm stand.
The Tablet / Phone Stand should work well for most tablets and phones provided the correct file is used for a snug fit.
This is a super easy print. Print them in your favourite color/s (pause and change colours part way through if you want to get creative) and great as a small gift.
Please refer to the print settings and images for additional information... and please post images of your stand/s in use for others to see.
Note: If you like this check out the rest of my practical and fun designs.
| Date published | 21/03/2017 |
| Technology | FDM |
Nice template, worked very well. I used the 10 mm template and it's great for my Nokia phone and Samsung tablet. The edges where you would put your phone require some cleaning. Printed with Anycubi Mega S, 2mm layer thickness.