Download > Panel Holder_001

Panel Holder_001

Category:Core P Series
File Size: 0.13MB

  • 4hr00min

    Print Time

  • 23

    likes

  • 7

    Comments

  • 1335

    Downloads

The panel holders are designed to sleeve into the metal pillar of Core P5 and hold up to 5mm of arylic, glass or any type of panel to cover the top, side or bottom of Core P Series. The file contains two type of holders, one has double side trails with a dimension of 42mm x 40mm x 42mm and the other one has a single side trail with a dimension of 42mm x 40mm x 27.5mm.

Download File

 I agree to the
 Limitation of Liability Clause.

Copyright Notice

This website and its content is copyright of Thermaltake Technology Co., Ltd. - © Thermaltake 2016. All rights reserved.

Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

• You may print or download to a local hard disk extracts for your personal and non-commercial use only.

• You may copy the content to individual third parties for their personal use, but only if you acknowledge the website as the source of the material.

• You may not, except with our express written permission, distribute or commercially exploit the content. Nor may you transmit it or store it in any other website or other form of electronic retrieval system.

Limitation of Liability Clause

Thermaltake Technology Co., Ltd. has no control over the conduct of Hubs and Users, the 3D Prints and services provided by Hubs, the storage or handling or any future use of the 3D Model by a Hub, and Thermaltake Technology Co., Ltd. disclaims any and all liability in this regard.

Thermaltake Technology Co., Ltd. shall not be liable, except for gross negligence and wilful misconduct, for damages, direct or indirect, arising from, but not exclusively, 3D print files, the printing process, or the products. Neither party shall be liable, except for illegal and wilful misconduct for any special, indirect, incidental, punitive, exemplary or consequential damages including, but not limited to, lost profits, even if the other party has been advised of the possibility of such damages.

SHOW THE WORLD YOUR WORK

Upload My File
Take a picture of your 3D model, upload it to our Gallery, and share your model with your fellow Makers. Have fun sharing!

Comments(7 )

  • MIke Phan
    1/27/2022 10:52:40 AM
    does anyone know the dimension of the glass panels to use this with?
  • Christopher Jimenez
    6/1/2019 7:41:33 AM
    Need these parts on separate files
  • Kevin Gu
    2/27/2019 2:57:25 AM
    Just realized this will not work with default glass panels after printing.
  • Gonzalo Novoa
    2/21/2019 1:13:18 AM
    Yo soy nuevo en la p5 pero espero poder hacer mis disenos y colgarlos para que todos puedan usarlos
  • Adam StCyr
    1/23/2019 2:38:44 PM
    Is it possible to get this as two separate files? 3D Hubs wont print it due to being multiple part
  • Keith Spencer
    5/8/2017 11:49:39 PM
    Has this problem been completed for single holders
  • Troy Hyman
    9/26/2016 6:33:38 PM
    It only has the double side trail in the file otherwise a great addition to the P3/5
  • Reply

    100 Characters Left

Copyright © 2016 Thermaltake Technology Co., Ltd. All Rights Reserved.