Examples -

Black (6cm x 6cm x 6cm) -

Printed on a Flashforge Creator Dual with  ReplicatorG software, which uses the Skeinforge slicing software.

Un-tick the option to generate support structure.

The angles used for the basket mesh should be shallow enough to not need support.

Print settings were :
Material : Black PLA
Extruder temp : 200 degrees C
Print Bed Temp : 50 degrees C
Support Structure and Raft option : Off
Feed Rate speed : 41
Travel Rate speed : 70
Layer Thickness : 0.27 mm
Took about 2 hours 47 minutes to print at a layer thickness of 0.15mm.

Yellow (7cm x 7cm x 7cm) -

Printed on Up! Mini with Up! slicing software.

Print settings used for this example :
Layer height 0.20 mm
Infill 50%
Took 4 hours 45 minutes to print, and 26.2g of filament.