I've designed a Hex and Triangle joint that needs almost no support, but you must print them the right way, the 'Peg' parts, (I called them 'POS') MUST be printed with the triangle point facing down, (their will be a tiny bit of support that will need cleaning below the triangle peg) and the parts with the hole, (NEG parts) should be printed with the triangle hole with the point faceing up, this way you don't need support and you don't need to clean support from the hole, which I always find a pain when people design like that!

Althought everything pushes together nicely, as this design is going to be suspended over your head, I would suggest a drop of glue on all the joints after you have finished assembly.

To create the 'Winter Shade', you will need to print;

8 supports
8 tall supports
16 Snowflake designs
2 Lamp_Pos-Tops
2 Pos-Middles
2 Lamp_Neg-Tops
2 Neg-Middles

Glue the Flake designs to the supports, before you assemble, everything else clips together and when you attach the lampshade to the light fitting that will help clamp the parts together, giving strength. As I said before this clips together, but as it's going to be over your head, a drop of plastic glue on the joints would just make things safe.

This design is slightly different from my other shades, their are two different types of support, this gives a greater 3D effect when you put a tall support next to a standard one.

Have fun, a lot of people think this looks great, please send us your photo's of your prints of the 'Winter Shade'.

Richard