OpenRC F1 Standard Rubber Tire Adapters

Prints (0)

Description

These are 3D printed adapters to allow the mounting of standard R/C F1 tires on the wheels from the original design. 

After printing the included tires with both TPU and NinjaFlex I decided that it needed real tires. 

I posted a driving demo with all 3 of my designs installed on the car: https://youtu.be/g154r7Dcjas

Front Suspension: https://pinshape.com/items/17983-3d-printed-openrc...

Rear Suspension: https://pinshape.com/items/19186-3d-printed-openrc...

Standard F1 Rubber Tire Adapters:https://pinshape.com/items/17752-3d-printed-openrc...

Instructions: Print 6x "Tire_Adapter_Supported" and 2x "Tire_Adapter_Supported_Front_Inner". 

Print the original rear wheels as-is. 

Print the front wheels, but set your slicer software to remove the bottom 6mm off of them. (In Cura the setting is called "cut off object bottom") This will allow you to use the narrower front tires that the normal F1 cars use. 

Remove the support rings. 

Press the adapters on both the inner and outer ends of the wheels and glue them with CA glue or similar. 

Fill the gap with a foam insert of your choice and mount up your new tires! 

The tires I used are: Sweep SW-F1FM 1/10 Formula 1 Front Tires V2 - Medium (2pcs with inserts) http://www.hobbyking.com/hobbyking/store/__65461_...

and Sweep SW-F1RM 1/10 Formula 1 Rear Tires V2 - Medium (2pcs with inserts)

http://www.hobbyking.com/hobbyking/store/__65461_...

Design Files

File Size

Tire_Adapter_supported_Front_Inner.stl
768 KB
Tire_Adapter_supported.stl
759 KB

Comments

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×