Warhammer 40K Handgun

Prints (-4)

Description

Due to issues with the PS servers my models are now available at  Cults3D (click)

This pistol goes perfectly with any Imperial Warhammer 40K cosplay, prints easily without any supports, is fun to paint and has a suprisingly nice balance when handled.

The way it was split ensures it will fit on any regular desktop printer and in addition makes clean painting as easy as possible. 

Print settings:

  • print at 0.1 - 0.2mm layers (I printed everything at 0.15mm)
  • 3-4 perimeters
  • 30% infill
  • no supports needed *  Grip: You can either print "grip_full.stl" vertically (will require minimal supports) or print the two grip halves ("grip_1.stl" & "grip_2.stl") and put them together with the dowels and some glue.

BOM (Bill of Materials):

  • Any glue that fits your chosen material (Superglue and/or 5-minute epoxy for PLA; Acetone for ABS)
  • 4x short countersunk M4 screws for the handle (decorative purpose only). Alternatively you could use tape or straps of cloth for a more post-apocalyptic look.
  • spray paint, acrylic/oil paints, etc.

Design Files

File Size

sights_front.stl
166 KB
receiver_front.stl
933 KB
receiver.stl
887 KB
grip_full.stl
3.26 MB
triggerguard_2.stl
331 KB
topcover.stl
280 KB
safety.stl
184 KB
grip_1.stl
1.65 MB
sights_back.stl
23.7 KB
trigger.stl
68.1 KB
barrel.stl
173 KB
triggerguard_1.stl
796 KB
receiver_back.stl
1.43 MB
handle.stl
505 KB
dowels_and_pins.stl
429 KB
maghousing.stl
1.48 MB
magrelease.stl
109 KB
grip_2.stl
1.69 MB
magazine.stl
524 KB

Comments

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×