Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
This is the modular long board bumper with leds. I created this because there was no cheap way to protect my long board from damage, so this was designed. I used 123d design to create the model. I printed this on a DIY flying bear 3d printer from china which is actually pretty good if you are in the market.
Layer height: .2 but you could go lower
Print time: about 4 hours
cooling: all fans on
Filament: shaxxon red
slicer: slic3r
rafts: yes
support: yes
infill: 10%
The way I designed this is so that it is universal due to the ball joints being able to rotate around the edge of the board. keep in mind this is a very crude model since my printer broke before I could make adjustments to the model. You will need to have some wiring ability since this deals with leds but if you want the easy out watch my video for my solution. Please enjoy my model!
and here is the link to my video:
Comments