Upgraded Cone Arm Wrestling Gripper

About:
Please note this download includes 4 (FOUR) files in 2 (TWO) sizes in .stl format of the Cone with Track Grip, both with and without knurling. This is NOT the physical product.

Almost been hit in the head by the cone grip? Hit no more with this as it has a track so the strap won't break free as easily!
Some slight knurling to help out, a tie-down strap, and Bob (or Dylan, or Frank, or Anne) is your uncle / aunt! I would recommend a 1-1.5m tie-down strap or webbing with a carabiner attached depending on how you're training, but measure as you need.

Things included in download:
1x Cone with Track Grip.stl ORIGINAL size, NO knurling
1x Cone with Track Grip.stl ORIGINAL size, WITH knurling
1x Cone with Track Grip.stl LARGE size, NO knurling
1x Cone with Track Grip.stl LARGE size, WITH knurling

RECOMMENDED PRINT SETTINGS:
Nozzle:
- 0.8mm

Infill:
- 15%; Gyroid (gives better strength; increase infill to 30% if using a 0.4mm nozzle)
- (I tried 30% first and it's fine, but very heavy! Would go to about 20% max, but I use around 15%-20%)

Material:
- PLA
- If you can print in ABS that would probably be better, but I used PLA and this has been fine holding up to heavy useage

Wall Line Count / Top/Bottom Thickness:
- 3 (for 0.8mm nozzle; would make this thicker depending on the nozzle size, or to be at least 1mm thick)

Top Surface Skin Pattern:
- Zig Zag / Lines
- Would not recommend concentric

Support:
- Yes