Chest/dice tower

Ideal for role-playing and other dice games, this 2-in-1 project is both a storage box for your dice but also a tool that will allow you, once unfolded, to roll your dice on a small surface.

I also put you a file to make a simple chest without the dice tower aspect.

Materials needed to make it:

• 3D printer of minimum capacity 12cm x 10cm x 10cm with filament (I used wood filament and metal effect filament but you can use other colors at your

as you like)

• glue

• something to make the hinge (I took two sewing pins and it works very well)

• you can also take scalpel and other blades to clean your prints (angel hair and supports) and clamps to facilitate the gluing

Printing:

• frame (metallic color board)

• handles x2 (metallic color advice)

• hood (wood color tip)

• for single box, print :

    o simple box (wood color advice)
  

• for box/dice tower, print :

    o box for dice tower (wood color tip)
  
    o recuperator for dice tower (wood color tip)
  

Assembly:

If you are printing the chest/dice tower, consider putting the hinge before the frame for ease

Glue the cover into the round part of the frame and the box into the rectangular part of the chest.

If you are making the dice tower, assemble the recuperator to the box by sliding a metal bar into the holes provided. Also, before gluing the box to the frame, pay attention to the direction to avoid being bothered by the lid during your games