Amiga 1000 custom Backplates

Amiga 1000 custom backplate

...with 1x or 2x HDMI slots and microSD slot.

This is my remix of the already available Amiga 1000 backplate from Thingiverse. Some dimensions weren't exactly correct (around 1-2 mm difference in some directions) and - the main reason - it wasn't printable on my Ender 3 Pro.

The panels are modular - so you can just print the panels you need - you need one HDMI port? You need two HDMI ports? You need a microSD slot? Just download the .STL file you want.

I placed the HDMI output above the RGB port, directly behind the RGB2HDMI Raspberry solution inside the Amiga. Also I have placed a 7 mm hole for the Switch most RGB2HDMI solutions use to set some preferences on the Raspberry Zero.

The right part was corrected by a few millimetres to fit the A1000's first 3 ports starting with the keyboard.
The middle part was completely redone - so new holes and an additional HDMI port.
The right part with the fan grill only has a fixed monitor port, now perfectly on the plug.

I only put the parts into the guide rail at the back of the Amiga 1000 housing. Usually there's no connection (e.g. with glue) necessary. But you can try if you want :)

Update

20/05/2022 - added a second variant of the first panel, now you can add a microSD card holder (https://www.thingiverse.com/thing:3164724) so you don't have to open your Amiga everytime you want to upgrade your PiStorm or add data to a partition on your PC

15/05/2022 - added v2 of the panels - sizes have been optimized - also the HDMI holes are now 27/27,5 mm width to fit most HDMI outlets (there are two variants, one with 1x HDMI and a second one with 2x HDMI slots)

Planned future updates

add recessed port descriptions (done, but not available so far)

-