Head Banger

Banging your head against a brick wall?

Now you can without the pain!

Or just Head Bang!

Instructions:

1. Print 2 brick walls and glue on top of each other
2. Glue main body onto base raised tabs
3. Glue triangles onto base snug against bases raised tabs
4. Glue brick wall onto base. Put glue onto backs of triangles and base edge
5. Glue Head onto platform. Make sure back of neck is even with back of platform. Also make sure the platform is facing in the correct direction.
6. Put glue into the holes on the sides of the platform and insert pins to hold platform onto upper base
7. Insert large dowel into lower base holes. Do not glue
8. Cut the bottom disk off the 3rd pin
9. Glue 3rd pin into hold on large disc
10. Glue disc onto large dowel making sure dowel is flush with the disc
11. Insert smaller disc onto large dowel on the opposite side. Do not glue
12. Insert handle onto large dowel snug against small disc and glue into place
13. Insert rectangle shaft onto both the platforms square pin and the large disc’s pin
14. Glue the square pin to the rectangular shaft. Do not glue the lower pin on shaft
15. Glue the optional “Bang!” onto the brick wall. Make sure that the top of the Bang is no lower than 2 rows down from top of brick wall.
16. Crank it and do some head banging!

-