MOTORCYCLE WITH SIDECAR AND TOOTHPICKS 3D print model

3D MODEL DESCRIPTION This is a model of an old motorcycle with a sidecar , when the rod is pressed downwards, a pushing arm rises upwards and takes out a toothpick while opening the doors of the sidecar .There are two models - one very detailed in which each part of the motorcycle is separate (to be honest it was a bit challenging to print and paste all these small parts).The second model The entire body of the motorcycle is a single unit, i Divided the body in half vertically so that printing is easy without much support and then gluing the two halves together, and it remains to glue together the body of the motorcycle to the sidecar , wheels, chair, and doors.There is room for a small rubber band at the bottom between the lifting arm and the body of the side car , (there are two holes where a small nail needs to be inserted and the rubber band is caught on them to make sure the lifting arm go oll the way down ,can work with out the rubber also ,).I used small nails with a diameter of 1.2 mm and pins of various sizes as hinges for doors, and reinforcement in the front fork and as decoration in places where there should be a hinge.If there are any questions I will be happy to help,