American Mecha - Whitworth WK1 Free 3D print model

This here represents my first attempt at a mech. I'm giving this one away for free, but your donations are always appreciated!

I chose this ugly duckling because there weren't a lot of options for this mech out there. I stayed as true as I could to the design from the 80s while adding some flair that I think you will all like.

This file comes PRE-SUPPORTED, Custom Cracked base IS included.

https://www.sarna.net/wiki/Whitworth

An excerpt from Sarna.

The Whitworth is something of an ugly duckling, known among both critics and fans as theTin Woodsman.It was originally produced in 2610 as a BattleMech that was meant to fill the weight gap between the lighter Wasp and the heavier Phoenix Hawk 'Mechs. The Whitworth, though, is slower than either of these designs by over 30 km/h and plagued with a faulty actuator system in its hips and legs which could cause the legs to tear loose during strenuous maneuvers. Replacing the actuators would require a complete reworking of the lower half of the torso and leg assembly. However, the Whitworth carried eight tons of armor, utilized four reliable Whitworth Jetlift jump jets split between both legs for improved mobility, and featured excellent long-range firepower. The result was a 'Mech that could stand up in combat to another 'Mech of its equivalent mass and less.