AtomRC Dolphin front cover 3D print model

Finally i desgined and sucsesfully printed few variations about Dolphin front hatch/ cover

Atomrc Dolphin front cover with different variations.

1. Cover as close to original as i could come
2. Cover sliced for half to print on printers with 180x180x180 dimensions- use super glue! Its easier to print anyway tbh.
3. Cover sliced with place for servo to use pantilt system (could modify for certain model of servo- i used GDW ds031mg 9g servo) and for 3mm tube to connect better two halfs
4. Cover with servo place with no connections
5. Cover sliced, wth servo place and printable connectos (included)

• If you want something to change, for e.x. other servo for pan, pm me.

Print settings for PrusaSlicer and Prusa mini

1. Polilite Pla:
2. Layer hight 0.2
3. Perimeters 1
4. Solid layers bottom 1, top-3
5. Infill rectilinear 7-10%
6. combine infill every 1 layer
7. Support for support enforcers only- paint it!
8. Speed:
9. Perimeters 35mms
10. infill perineters overlap 22%
11. Print temp 220 st.C
12. Bed 55 st.C