SCREWDRIVER AND BITS HOLDER (Compact Version)

We have designed the compact version of our all-in-one screwdriver and bit organizer so you can carry it in any backpack. It's 100% functional and packs quite a punch when it comes to tightening screws.

The design is prepared to carry magnets that will help to hold the tips and makes the part of the base can stick on any metal surface (as seen in the photos).

We used 5X2mm magnets, you need one magnet per tip, here is a link, but you can look for any that are the same size:

https://a.aliexpress.com/_EQZK9aH

All designs for each of the pieces to fit together, have a space (offset) of 0.30mm between them, so if your printer is well calibrated, all parts should fit well including the tips and magnets you use. The tips are not gripped, it is intended to enter loose in the holes and grab the magnets. Note also that although it is intended for the standard size of screw tips, but you may have a little thicker because the manufacturer has not made them correctly, if so, you can fit the tip into the hole even if it is difficult to enter and then give heat to the tip itself to widen the hole a little and so you can use them, or also use the expansion option.

horizontal from your laminator.

Screwdriver:

• Layer height: 0.2mm

• Wall thickness: 0.4mm (i.e. 1 wall line)

• Filling: 100%

• Supports: none

Base:

• Layer height: 0.2mm

• Wall thickness: 1.2mm (or in other words, 3 wall lines)

• Filling: 30%

• Supports: none

Top version A / Top version B (Choose one of them, the one you like the most):

• Layer height: 0.2mm

• Wall thickness: 1.2mm (or in other words, 3 wall lines)

• Filling: 30%

• Supports: none

This is so that the cover drawing will print correctly:

• Combed mode: all

• Maximum combing distance without retraction: 4

(you must have the first layer well calibrated)

We are at your disposal if you have any questions:

https://www.instagram.com/filaworks/

filaworksespana@gmail.com