One day I thought to myself, why not combine what I have been doing and make a dice tower as I have not seen any 3d printable scifi vehicle miniature that also acts as a dice tower AND also a card holder.

I have never done anything like this before as I have to design this model in pieces and be able to put it together like a model kit. The top is designed to be able to flip open to act as the tower and the rear of the crawler can flip down as well for you to store your game cards inside. The crawler itself is designed for 6-10 mm scale games. It is quite big because I have to make sure the interior has enough space to store cards and be a dice tower. Of course, you can scale this up by about 280% for 28 mm games if you choose to do so. 

You will be getting the main crawler in 12 pieces

• left
• right
• top
• bottom
• rear
• 2 front tracks
• 2 rear tracks
• large cannon
• small cannon
• ramp add-on
• large missile module
• microwave cannon module
• howitzer module
• scout vehicle (fits inside the crawler)
• the interior can fit about 80Magic The Gathering cards without sleeves. For those who don't play Magic The Gathering, the size of each card is 6.3 x 8.8 cm in size. In the prototype I have also added velvet to cover up the interior to minimize the damage it might cause to the cards.

Full size at 100% is about 12.8 cm wide x 7.75 cm high x 20.6cm long. Prototype printed at 85%.