B-25 Mitchell - Wing Servo Connectors - 3DLabPrint

Wireless plug in wings.

Another rendition of these:

Spitfire Mk IX https://www.thingiverse.com/thing:4143803
F4U Corsair https://www.thingiverse.com/thing:4178322
Il-2 Sturmovik https://www.thingiverse.com/thing:4132256
EDGE 540 46” https://www.thingiverse.com/thing:4128056
EDGE 540 73" https://www.thingiverse.com/thing:4368656
Qtrainer https://www.thingiverse.com/thing:4137667
P-51 https://www.thingiverse.com/thing:4186416
Focke-Wulf Ta152H https://www.thingiverse.com/thing:4195584

These utilize 2.54mm JST-XH connectors and standard servo connectors..

These were designed and implemented BEFORE the Inner wings were assembled to the gondolas.

You could retrofit them to an assembled plane, but you'd need a "template on a stick," a steady set of hands when gluing, and a long magnetic screwdriver.

Each Inner and Outer wing port consists of a Mounting Ring and a Plug Plate.

An Install Template is screwed to the corresponding Mounting Ring, and with CA applied 5mm down inside the wing tube, the assembly gets pressed into the wing tube.
The Template is positioned flat against and all the way to the Front of the wing tube.

Once the glue is dry, the Template is unscrewed and is replaced by the Plug Plate. The Template can then be discarded/recycled.

A Filler Plate is used on each Outer Wing behind the Plug Plate, to retain the XH connector and allow for easy repairs if necessary. It is NOT glued in.

To keep it from being pulled out when the Outer Wing is removed, cut away the little locking tabs in the slots of the Inner Wing connector, and CA glue the connector into the Plug Plate.

The connections to the XH base connector in the Inner Wings are the Female pins that came with the JST-XH kit. They are crimped, pressed onto the pins, soldered, then heatshrunk.

The connections in the Outer Wings are the same Female pins from the XH kit as used on the back of the Inner Wing connector wiring.

The additional is just standard servo connectors.

NOTES:

Printed in PLA+, 25% Infill

All Templates, Plug Plates and Mounting Rings are printed face down.

The Left and Right Filler Plates are printed with the indentation UP.

I used 2 ea M3x10 self-tapping screws to secure each Plug Plate to it's Mounting Ring.

If you find that this makes your flying sessions MORE enjoyable with LESS hassle, please consider buying me a cup of coffee at

paypal.me/MakeItMakeItMakeIt

Thank You!

-