Dumbells stand - Industrial looking

Industrial looking dumbell stand.
Holds two dumbells.

Max diameter of the handle: 29mm.
Max diameter of the weight disks: 250mm.

There is seperate inserts on the modell, at where you put down the dumbells on. They are made of 30D TPU, which is very durable, and flexible. This will help from scratching/breaking the main structure. Also gives a more soft "landing".

These inserts are "Click" in place, so easy to mount/replace if needed.

The screws holding all the spacers are just threaded into the plastic.
You can use a bit of force (and maybe a drill) to just thread them in, or use threading tool to makes threads.
(No need for extra metal heat inserts here, since these just hold the structure together. Will be no load on them)

BOM
(Bill of materials - You must buy this on your own-)

• 16 pcs, Screw M5x25 mm
• 6 pcs, Screw M5x16 mm
• 6 pcs, Nut M5 __________________________

Assembly:

1. Mount the two halfes of the struckture toghether with the M5x16 screws, for both sides.

2. Insert the 4 pcs TPU inserts. A blunt flat screw driwer can help push the lips down under to where it locks in place.

3. Start mounting the spacers, one at a time.
   No need to fully tighten before all are in place. A drill is handy if just threading the spacers with the screws. Goes fast and easy. Just be sure to use some force so you dont just drill out a holde with the threads. Final tighting should be done by hand with hex key! (Dont over tighten!)
   If the frame is a little skewed after assembly, thats normal. Just twist it straight by hand.

4. Go do some workout, and have them tested!

Material:

• The two main structures and all spacers prints in PLA.
  PETG even better but not necessary.

• The inserts prints in 30D TPU (or similar).

• See pictures for print orientations.

Model size:

• The model prints in 4 main pieces. The longes piece is 219 long (and 130mm wide.

Total length of model when assembled is 397mm long, 122mm wide and 130mm high.

Print settings (Side A & B):

• Layer height: 0.2mm
• Walls: 10
• Top/Bottom layers: 10
• Topp/Bottom line direction: "0,90" (Cura)
• Infill: 25%

Print temps, flow and speed according you what you use for desired filament of choise.

Small amount of support is needed for screw holes towards the bed and inside where the tpu inserts go.

::Caution::
Remember to add a filament color change for the logo (last 5 layers, if printing at 0.2mm layers height)

Print settings (Spacers):

• Layer height: 0.2mm
• Walls: 50 (unlimited)
• Top/Bottom layers: 10
• Infill: 100%

Print temps, flow and speed according you what you use for desired filament of choise.

Supports not needed for spacers.

Print settings (TPU inserts):

• Layer height: 0.2mm
• Walls: 50 (unlimited)
• Top/Bottom layers: 10
• Infill: 100%

Print temps, flow and speed according you what you use for desired filament of choise.

Supports not needed for TPU inserts.