Sword Display - Wall Mount Hook Display Stand

I always wanted a sword collection of my own. Now that I'm older, and that this wonderful technology that is 3D printing exists (and is somewhat affordable), I am able to dream of this again, but every collection needs to be displayed and organized somehow.

This is a rotating wall hook mount, designed to fit all sizes of swords. It's "arms" rotate to accommodate any width of blade and hilt. It also comes with a larger arm option, in case you have an extra wide sword, or want your sword to hang a little lower.

It comes with two pieces to form each rotation axis, however, if you can use a metal axis, like a nail, all the better.

Also, it comes with a detachable cap, to hide the screws and axis pieces. you can use some double-sided tape to temporarily glue it.

You need to fix it to a wall with a screw from the top hole, it is 7.5mm in diameter (0.28 in)

If you like the swords featured here, you can check them out, and some more, here: My creations

The complete short hooks model is 5cm x 10 cm approximately, while the long hooks version is about 5cm x 13 cm

I recommend high infill to improve mechanical strength.

Disclaimer: This was designed to hold 3D printed swords (which are lighter in weight than real swords), and its strength will vary depending on the material you print in. Always test your print with some weights to know if it will hold your sword without breaking.