Cupholder + Center Console for 2nd generation Chevy S10

This is a cupholder that will fit into the bench seat of a 1994-2004 Chevy S10/GMC Sonoma. It was designed to fit in the same mount as the removable factory cupholders. I made a design that would replace the cupholders, along with a variation that comes with a center console.

All of the parts are sliced into different pieces to be super glued together. I did this to reduce the amount of support material required, along with the ability to print these on smaller printers.

The only supports needed are for the base/bottom half. Also, the L shaped guides should be printed separately with a higher infill density for extra strength. With a lower infill, they could snap off (I learned this the hard way).

Notes:
- I do not recommend using hot glue instead of super glue because it could soften in hot summer conditions. You can see that my console lid is a bit warped due to the heat, but it still works fine. (I used PLA)
- You will not be able to fold the bench seat down with the center console there. This is why I made a cupholder only design so you would still have access to the middle seat and behind the bench.
- These cupholders are removable in case you want to swap it out for something else. It uses the same mounting design as the factory cupholders.

Layer Height: 0.2-0.3mm
Supports: Only when needed
Infill: 10%, at least 80% on the L shaped guides.