NOMADIC SOLAR

Mounting kit for flexible solar panel nomadic version.

Single or double, this kit ensures the protection and the good holding of your equipment.

Its adjustable support guarantees maximum exposure in summer and winter.

Away from civilization or just as an emergency secondary energy source, I hope you enjoy this economical setup possible with various panels with grommets.

I made this set up after experimenting with the use of flexible panels that are despite marketing communications, fragile to handling

Realization:

• 27 mm by 13 mm cleat, adjust to length according to your panels.

• electrician's collar ligature width 3.6 mm or equivalent

• 3 mm diameter rope.

• self-tapping wood screws diameter 4 mm length 16 mm

Model shown:

• two times 60W ( 120 W )

• panel : 610 mm x 540 mm

• closed dimension : 680 mm x 610 mm

• open size: 1220 mm x 680 mm

• weight : 3,5 kg

Folded, the module is easily stored horizontally or vertically in a van or in the trunk of your car.

A center grommet hook not shown is available for 100W panels.

I wish you a great realization and stay tuned for any constructive criticism.

• PLA printing without support

• 3 walls

• 50% filling

• FILAFLEX or TPU hinge tongue

Depending on the size of your cleats, increase the scale by a few percent

Test with the MIDDLE EYE as a template.

Orient your pieces to have course bridges .

Drill the thin walls of passage of horizontal screws at the assembly, technique to avoid supports .

See screenshots at the time of the bridge and final printing .

Good realization

A maker who wants to do you good