FX Impact .25 Pellets Care Magazine

Take advantage of the Pellet Care Magazine.
Here in the cal. .25 version
It is designed especially to be optimized for pellets, but is working very well with Slugs too
Updates : 30-11-2022 Added a smaller diameter center washer.

Link to an instruction video, how to finishing the magazine after printing: https://youtu.be/wunxeoAX39A

Link to how to make the Tension spring:
https://youtu.be/AMW_z_x5rE0

Further information about spring and assembly here:
https://1drv.ms/b/s!AmpEb51MwLqTh_cxLXGupN7SXw9Ycg?e=i4dbLF

Further information about spring and assembly here:
https://1drv.ms/b/s!AmpEb51MwLqTh_cxLXGupN7SXw9Ycg?e=i4dbLF

Further information how to finish the rotor:
https://1drv.ms/b/s!AmpEb51MwLqTh_drfERkPLcn6EEa8g?e=yJKrTe

Shopping list can be found here:
https://1drv.ms/w/s!AmpEb51MwLqTh-ctFHBkykG6XComug?e=rQTOML

I use ABS printed on a glass bed with DimaFix spray at 100 degrees C.
I also sometime use Petg for the body, washer, and cover, but very seldom for the rotor. The rotor is coming out of the printer with superior quality – specially numbers are easier to print with ABS. Also removing the support for the O-ring will be easier without damaging the rotor.

I print all with 0.16mm layer height. Be sure to calibrate your printer at optimize your slicer. Everything is designed to 0 tolerance so use your slicer XY horizontal compensation.
The Rotor holes for the pellets is best when drilled out carefully with a sharp drill before the O-ring support is removed. Print the rotor with the numbers towards the print bed.
I prefer quality over speed so i print at 50 mm/s.
When I print with ABS scale the parts in X and Y 100.4% not in Z.
Note the stop pin for the pellet on the body must be reinforced with a ø1 - ø1.2 mm steel pin or like I do with a ø1.2 mm solid carbon rod.
Use thin or super thin Cyanychrolate glue. Do not try the mag without this pin reinforcement. Cut m3 threads in the 2 holes for the m3 x8 countersink steel screws. One for the center and the other two for the Magnets.
Use two ø6x 2,5 neodym. magnets for the cover. I use ø6 x3 since they are cheaper. Just screw the two m3 screws just below the body surface to absorb the 0.5 mm the magnets are too long.
Use a 1.2 mm steel or carbon rod for the hinges. Drill free with a 1.2 mm drill first while the cover is fixed in place. (You can fix the cover temporary by the 2 screws for the magnets before fitting the magnets,
Infill 30%
Supports when printing.
Body: only touching bed.
Cover: no supports
Washer: no supports
Rotor full support
I recommend using the .3mf files over the .stl files - The .3mf files will give smoother roundness.