Marvel Legends Generic Interchangeable Hands

By purchasing this files, you agree to not sell or redistribute them.
You can't mass produce and sell the 3D printed objects.
If used, attribution is really appreciated.

WARNING:
Not recommended for small children: choking hazard.
The maker is not responsible for any untoward incident that might occur as a result of a misuse of the product.

Features:
- 2 pairs of open hands;
- 1 pair of web shooting gesture hands;
- 2 pairs of pointing hands;
- Fists;
- Hands for holding guns;
- Hands for holding swords;
- Grabbing hands;
- OK gesture hands;
- Gun gesture hands;
- Hands for dynamic poses.

INSTRUCTIONS:

The hands are designed so you can make your own pivot. Just slide, bend and twist a twist tie in the slit on the hand and harden the twisted part with superglue or scotch tape. This way you will get a pivot similar to the one used in marvel legends action figures and it could potentially fit almost every figure without any modification.

Painting required.

COMMON ISSUES:

• The joints are too tight and won't fit/move at all.
  Solution: Try increasing the scale of the models by 0,1 mm at a time. Alternatively you can try sanding down the pegs (but this could weaken the joints).

• The joints are too loose, the hand doesn't keep the poses and or falls apart.
  Solution: Try decreasing the scale of the models by 0,1 mm at a time. Alternatively you can try to tighten the joints with paper tape.

Material: PETG/PLA
Supports: Yes
Infill: 20/30%
Resolution: 0.1