Stroganov organizers

Organizers for Stroganov board game. All organizers fit the game box very well and provide quick game setup. Theme reliefs decorate lids.

The set contains: Resources organizer, Player's components organizer, Village&SetupFur organizer, Yurt&Song organizer, 2 Landscape holders and Card tray.

1. RESOURCES ORGANIZER: The container has 5 sections to accommodate different types of tokens: Horses 1 and 3, Coins, Tigers and Banners. Rounded bottom facilitate item draw. Sliding lid prevent components from falling out during the storage. I suggest 3d printing 2 of such organizers, so they can be placed on 2 sided of the table, so all players can easily reach for tokens. However all components fit one organizer.
2. PLAYER'S COMPONENTS ORGANIZER: There's a small container, where all components in one color are kept. As there are 4 sets in 4 colors, 4 small containers should be 3d printed. They are accommodated in a main container. This container is decorated with lace pattern cutouts that are related to player boards. Sliding lid covers the main container to protect components during the storage.
3. VILLAGE&SETUPFUR ORGANIZER: Village tiles and Set up Fur tokens are kept here in 2 sections. Season marker comes along. Again a sliding lid secures components during the storage.
4. YURT&SONG ORGANIZER: Yurt and Song tiles are accommodated here in 4 sections. Tiles A are separated from tiles B. There's a wide gap between each deck, so you can pick tiles up comfortably.
5. LANDSCAPE HOLDERS: There are 2 Landscape holders. S is small, for the Starting tile and 5 Starting Landscape tiles. High is for the rest Landscape tiles. Indentations facilitate taking tiles out.
6. CARD TRAY: One tray has 2 sections for 2 decks. Indentations facilitate taking cards out. There are 4 decks in the game: 3 types of Tsar's Wish cards and Automa cards, so 2 Card trays should be 3d printed. Starting Tsar's Wish cards and Automa cards are kept in one tray, Tsar's Wish cards A and B - in the other.

Some photos in higher resolution:
The set
Game set up for 4 players
Resources organizers
Village&SetupFur organizer
Player's components organizer, photo 1
Player's components organizer, photo 2
Packed
Partially unpacked
Half unpacked
Almost unpacked

All organizers were 3Dprinted on Prusa MK3:
- in PLA (F3D Gold pearl),
- No support is needed,
- Infill 10-15% rectilinear.
Note1: I use slightly changed default Print settings "0.15mm SPEED MK3" in PrusaSlicer.
Note2: I used 1 vertical perimeter and Monotonic top fill to increase quality of reliefs.
Note3: I used 0.2mm layer height for Card tray and Yurt&Song organizer to speed up the print.

Printing Time (for one organizer of each kind):
7h32' - Resources, container
2h50' - Resources, lid
6h44' - Player, main container
2h41' - Player, lid
6h58' - Player, small container x4
2h43' - Village, container
1h40' - Village, lid
2h21' - Landscapes S
4h40' - Landscapes High
3h52' - Yurt&Song
1h18' - Cards