Di3play - Wanhao Duplicator i3 Plus LCD Display Enclosure

LCD enclosure for Wanhao Duplicator i3 plus (mine is a Mark 2)

Based on the PCB slot from the excellent "Wanhao Duplicator I3 Plus LCD enclosure by bosbessenbasje"

Remixed to incorporate the following:
- Raised viewing angle to 50 degrees
- Recess around MicroSD slot
- Mounts into printer front panel recess (no additional fasteners required)
- Floating design with base above table surface - unaffected by use of printer levelling feet etc
- Bottom plate which acts as retaining clip

To install:
- Remove bottom plate from printer to disconnect LCD flat ribbon cable (I tried from the front only - but you risk damaging the ribbon)
- Push the PCB into slot from the bottom until it clips into place (there are retaining clips for the top holes of the PCB. To remove PCB use a screwdriver at the top of the vertical slots on the back of the enclosure upper)
- Clip upper enclosure onto the top edge of the printer front aperture (start at one end and push to clip on)
- With the front of the printer overhanging the edge of a table insert the hook of the enclosure lower clip onto the bottom edge of the printer front aperture (see photo)
- Swing clip up and clip under front edge of PCB

(Note I increased the size of the SD recess in the model after printing - there is now a small bridge but it should print OK )

-