Mushroom Joint Container Fungi Keychain Joint Holder

This mushroom-shaped keychain has a special compartment that will allow you to store a joint of up to 1 1/4" inside.

DISCLAIMER:

This product does not include a commercial license, that is, it is for personal use only (CULTS PU LICENCE) and you cannot profit from this 3d model without a commercial license or my written authorization, thank you very much for your understanding!

General parameters:

Nozzle size: 0.4mm - 0.6mm
Layer Height: up to 0.32mm (I recommend 0.2mm)
Supports activated for "Stem.slt" and not needed in "Cap.stl"

Note:
the .3mf files contain the printing parameters that I use in my different ender 3s, they are used for both direct drive mod and bowden tube

Recommendations:

I recommend printing "Stem.stl" with the same orientation that comes in the file since in this way the greatest possible resistance is achieved, if it is printed perpendicular to the bed it is possible that the thread breaks

"Cap.stl" does not need supports since with the included supports it can be printed. For this I recommend good layer ventilation, increase the "minimum layer time" in curing and lower the temperature by about 10°...
This works for me:
Minimum Layer Time: 20s
Minimum Speed: 8mm/s
Lift Head: NO

For the "Stem.stl" supports my recommendation is to increase the density of the support and at the same time reduce the material flow of the support.
This is what has given me the best results:

Enable Support Interface: YES
Enable Support Roof: YES
Support Interface Flow: 40%
Support Interface Density: 80%