PS4 Pro Vertical Stands

**Added a V3 and V3.5 version. With the newest PS4 firmware, you can now use external hard drives to store games. I went ahead and bought the Seagate - Backup Plus Slim 4TB external HDD, and found it fits perfectly on one of the wings of the V2 stand. I went ahead and added little rails to each side so that you can rest a HDD on its side there. V3.5 is the same thing but with cut outs in the middle section to hopefully(?) reduce print time. Let me know if these work out for you.

**I added a new V2 version with wider feet. I again made a shorter and a taller version. The feet are about an inch wider on each side than the space where the PS4 occupies, and I have to imagine that's a decent enough amount to keep it from tipping over. especially when using the taller versions. I've left the old versions up in case you trust that amount of support and/or don't want the increased print time. I have not yet printed out the new V2 version yet, so let me know if there is an issue.

Simple stand for the PS4 Pro. Simply took a measurement of how wide the system is (I measured about 54.91 mm), threw this super simple thing together in 3D builder, stuck it in Cura, and then printed. You will need to print at least two of these.

They are not fancy at all, but it seemed to fit nice and snug, and kept the system from wobbling as much as it does normally (which honestly isn't much; it's at least better than the OG PS4 as it's a little bit wider). I made two versions, a taller one that is about 1.8 inches (46.9mm) in height, and a shorter one that is an inch less at .81 inches (20.6mm). To just test it out with a quicker printer, I shrunk the shorter one to 60% its original height in Cura and printed that, and it seems to work even when that small.

I printed the test version at .3mm layer height, with 1.2mm shells, and 25% fill. It took about an hour to print one of the test versions on my Maker Select V2.1.

/After thinking about the design for more than 5 seconds, these (the original designs) are actually probably worse footprint wise than the original console. If I can get some more time, I'll try and come up with something more foolproof. /Added a new version with wider feet.

-