Kato N and HO Gauge Multi-Purpose UNITRACK Connector Pin

This track connector pin can be used as:
- a dead track isolation pin, (just use as-is)
- or wired to act as a switch or relay controlled jumper pin
- or wired as a normal conductor pin
- or wired as feeder pins.

It is compatible with Kato brand UNITRACK N gauge and HO gauge track.

Wiring Instructions:
Use 22 solid wire, or 24 gauge braided wire.

To wire as a switch or relay controlled jumper:
- strip insulation from 2 wires to expose about 10 mm bare wire on each.
- insert each bare ends up through the center-most holes
- bend protruding bare ends into a U-shape, and pull each down into its nearest outer hole.
- attach switch or relay to the other end of the wires.
-Note, you must also use a second (unwired) "dead" pin at the other end of the track section that you want to control. This second pin must be on the same rail.

- When switch or relay is closed, the dead track section will be powered from the adjacent rail.

To wire as a normal conductive pin:
- strip a short piece of suitable wire entirely.
- bend into a U-shape
- insert up through center-most holes
- bend ends into a downward U and insert into outer holes.
- pull back ends back to toward the bottom, twist together and then trim excess length.

To wire as a feeder pin:
- use 2 pins, one for each rail, and wire as normal conductor pin, except leave one end of each wire long.

Due to the fine detail of this print, you must use a .2 or smaller nozzle for FDM printers. Best results will be obtained with resin based printers. (see photo for recommended resin printer orientation - no supports or base needed).