RAINBOW SIX SIEGE (BOOBY TRAP - KAPKAN TRAP)

English:

Hello everyone, I bring you a model of the booby trap used by the KAPKAN operator of the defenders in the game Rainbow Six Siege.

The design is made for minimum 26mm wide door frames.

The model can be fitted and removed just like the original set trap.

If you want to make it as close to the game as possible, you will need the following:

• 2 small metal hinges 1 1/2" high x 30mm wide as seen in the pictures.

• 4 small countersunk head screws for the hinges.

• 1 1/4" diameter x 3" long hex head lag screw.

• 1 cyanoacrylate glue.

• 1 piece of green circuit board (I got it from an old hard drive board).

• 1 piece of red, blue and green wire.

I hope you enjoy this model as much as I enjoyed designing, printing and assembling it.

Español:

Hello everyone, I bring you a model of the booby trap used by the KAPKAN operator of the defenders in the game Rainbow Six Siege.

The design is made for door frames with a minimum width of 26mm.

The model can be placed and removed just like the original game trap.

If you want to make it as close to the game as possible, you'll need the following:

• 2 small metal hinges 1 1/2" high x 30mm wide as you can see in the images.

• 4 small countersunk head screws for the hinges.

• 1 1/4" diameter x 3" long hexagonal head screw.

• 1 cyanoacrylate glue.

• 1 piece of board or circuit of green color (I got it from an old hard drive board).

• 1 piece of red, blue and green wire.

I hope you enjoy this model as much as I enjoy designing, printing and assembling it.

English:

-You can print it on any non-flexible filament (PLA, PLA+, ABS, PETG, ASA, etc...).

-Layer height: 0.2mm

-Supports: not required

English:

-You can print it in any filament that is not flexible (PLA, PLA+, ABS, PETG, ASA, etc...)

-Layer height: 0.2mm

-Supports: they are not necessary