Joaquín Sabina's Wall Clock (Joaquín Sabina Wall Clock).

It is a watch to be made in two colors. It is designed on the TINKERCARD platform. The lower part has a height of 2 mm and the upper part of 1 mm. The original size is 14,22cm x 19,70cm, although these measures can be adjusted to the size you prefer. It is printed in PLA PRUSAMENT, but accepts any type of filament. Work done with an ENDER 3 PRO and configured with the ULTIMAKER CURA laminate at 0.20mm layer height and a print speed of 30/40 mm/s (30mm/s I put it on the top to give better detail). It took 13 hours to make. Once finished added clockwork and ready to enjoy.

 I upload 5 STL:





 1 stl of the complete clock; other 2, of the base of the clock and the upper part respectively with hole and other 2 of the two parts without hole, in case you want to make some kind of modification, (like for example: put the hole bigger or smaller or put it in another place).


  I also add a picture hanger so that the clock is straight when hanging it, you can modify it in TINKERCAD, I put the width of the thickness of the watch case, so that it was straight and I glue it at the top almost at the top and it was perfect, I think it is a good solution to hang it and that it is straight.





 I hope you enjoy it as much as I did making it and printing it.

It is a simple watch model for all lovers of this Spanish singer-songwriter.

 It is a watch to make two colors. It is designed on the TINKERCARD platform. The bottom has a height of 2 mm and the top of 1 mm. The original size is 14,22cm x 19,70cm, although these measurements can be adjustable to the size you prefer. It is printed in PLA PRUSAMENT, but accepts any type of filament. Work done with an ENDER 3 PRO and configured with the laminate ULTIMAKER CURA at 0.20mm layer height and a printing speed of 30/40 mm/s (30mm/s I put it on top for better detail). It took 13 hours to make it. Once it was finished, a watch machine was added and ready to go.





 I climb 5 STL:





1 stl of the full clock; 2 others, of the base of the clock and the top part respectively with hole and 2 of the two parts without hole, if they want to make some kind of modification, (such as: put the hole bigger or smaller or put it in another place).


 I also add a plaid hanger to make the clock straight at the time of hanging, it can be modified in TINKERCAD, I put the width of the thickness of the watch case, so that it was straight and stick it on the top almost at the top of the whole and it was perfect, I think it is a good solution to hang it and make it straight.





 I hope you enjoy it as much as I do and print it.