LIS3DH / LIS3DSH removable mount Tevo little Monster

GERMAN:

This is a bracket to install an accelerometer on the effector of a Tevo little Monster. LIS3D(S)H is used as an accelerometer on Duet3D/RRF.

This mount has become removable out of necessity, as the mount did not provide enough space without colliding with the pushrods.

First, the base is screwed to the existing holes that also hold the BLTouch, covering the two fan mount screws.

Then simply slide the top with the pre-installed PCB LIS3DH onto it.

Cover on it ready. Now the electrical connection. I used JST connectors. The opening is also sufficient for this.

Screws used:

Pan head screws 3x5mm 2pcs to fix PCB in TOP.

Cap screws 3x10mm 2pcs to fix BASE to Effector.

PS: I don't use the stock fan holder, so the holes are fully available for the BLTouch.

ENGLISH:

This is a bracket to install an accelerometer on the effector of a Tevo little Monster. LIS3D(S)H is used as an accelerometer on Duet3D/RRF.

This mount has become detachable out of necessity, as the mount did not provide enough space without colliding with the pushrods.

First, the base is screwed onto the existing holes, which also hold the BLTouch, so that the two screws of the fan mount are covered.

Then the top with the pre-installed PCB LIS3DH is simply pushed onto it.

Cover on done. Now the electrical connection. I used JST connectors. The opening is sufficient for this.

Screws used:

Lens head screws 3x5mm 2 pieces to fix PCB in TOP.

Cylinder screws 3x10mm 2 pieces to attach the BASE to the Effector.

PS: I don't use the stock fan holder, so the BLTouch's extinguishers are fully available.

Layerheigt 0,2mm; Support needed, nothing else