Joker Hookah / Shisha

Dear Hookah Friend,

i was working on a Hookah since 3 years and created lots of different designs. This is my Joker hookah. You have to put a bullet like a glass sphere (7mm) in the base while printing. You can also testing a printed bullet if your printer is really accurate in printing round figures. I am using a stainless steel rod (14mm diameter) as a dip tupe. My rod goes through the hole joker pillar and ends in the water o the bowl. You can also try to use a printed dip tupe. At the top of the pillar there is a place to put a magnetic ring on for holding a metal plate. It is designed for a magnetic ring in the demension 27x21x3 [mm].

The hole printing time is round about 30-35h. The bowl is printing with a .8 nozzle (.25 layer height). The rest should be fine with a .4 one. With this offer you will get 2 pillars as you can see on the photos. Next to the joker pillar you receive a "normal" spiral pillar. too. Both fits perfectly to the base which is locked by a bayonet mount.

If it's not capable for you to print waterproof bowls you can send me a message on my instagram account (CreateSmoke) for buying a printed hookah with a magnetic plate and black or white tupe.

The hole printing time is round about 30-35h. The bowl is printing with a .8 nozzle (.25 layer height). The rest should be fine with a .4 one. Take your own preferred settings. Every printer needs its own settings, but this design gets good results with a bad printer, too.