Camera Apple Pencil Clip

Are you a passionate photographer spending a lot of times on your iPad. Look nowhere else for an excellent way to customize your Apple pencil!
The Camera Apple Pencil clip for your Apple Pencil is compatible with the 1st and 2nd generations.

The design is perfectly compatible with magnetic charging. Moreover, it will stop your Apple pencil from rolling over when on a flat surface.

Thanks for checking out this clip - be sure to check my other creations for more cool designs you might like!

Please, tag me on Instagram or TikTok (@Holoprops); I would be thrilled to see your prints!

⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a supporter on the Thangs Membership:
🔵Thangs - Membership

All my Designs are covered by a Creative Commons Non-Commercial License on Cults 3D. The sale of prints using my designs is the sole right of myself, the designer, and my active supporters to do so. Please understand every design is many days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:
• Use a raft!
• Layer Height 0.2mm or 0.15mm
• Nozzle 0.4mm
• Recommended infill 20%.
• Do not print over 50 mm/s. A lower speed like 40 or even 30 mm/s will always produce better results.
• Make sure your bed is correctly levelled. Then check again :D
• Try to hide the seam and place it where nobody will pay attention.
• Make sure your printing temperature and bed temperature is adequate for the filament you are about to use.

Happy printing!

HOLOPROPS