Ka-bar lightsaber scabbard - Ultra Sabers compatible

A lightsaber scabbard to carry lightsaber in a more stylish way. Make your lightsaber look like a Ninja sword (ninjatō).

This design was a request to make a scabbard that looks similar to the leather handle of a Ka-bar knife.

The scabbard is compatible with the Ultra Sabers Initiate V2, Aeon V2, Apprentice V4, Initiate V3 and probably many of their other designs. This accepts a 1 inch diameter blade.

The body portion of the scabbard comes in two designs, with holes and without holes. Mix and match to get the look and length you desire.

Lightsaber NOT included.

You will still need:
* about 2 yards (1.8 m) strap 1.5" (38mm) wide.
* 2 rectangular rings 1.5" or 2" wide.
* 1 adjustment buckle 1.5" or 2" wide
* needle and thread to sew the strap to the buckle and rings.
* super glue
(I will provide links to examples).

Lightsaber NOT included.

PRIVATE USE ONLY.

0.1 or 0.2 layer height
20% infill
Supports ONLY touching build plate.
No raft

The inside diameter of printed part should just be enough to have a light friction fit for a standard 1 inch (25.4mm) diameter blade. the Lightsaber should be easy to draw out but will stay in place when scabbard is held upside down. If too tight, scale model from 101% - 102%. If too loose, scale model from 99.75% - 99%.

Two parts will require to be paused during print to drop in and capture the Rectangular Ring in the ring holes.