TMNT 1990 Movie Logo Magnet Display Teenage Mutant Ninja Turtles

I have created the Teenage Mutant Ninja Turtles 1990 movie logo into a magnet/shelf display badge. These files/models have been created for use with a Dual Color/Hotend 3D printer or an IDEX 3D printer. I personally have the Sovol SV04 IDEX 3D printer and print this with no problems. The printed pieces consist of 1 physical piece with the primary.stl as either the dark green OR black colored filament and the secondary.stl as either the yellow OR green filament respectively. Dark green OR black filament spool in hotend #1 and yellow OR light green (respectively) in hot end #2. Super glue the magnets into their cutouts on the backside. I use Cura to merge the 2 colored stl files together. A total of 4 magnets are used. The magnets used for this diorama can be purchased using this Amazon link, https://amzn.to/3BBmX4b Also included in the downloads section is the shelf display stand which prints in 3 total pieces and can be printed all at the same time arranged on the bed. The stand is pretty simple to assemble, just insert the vertical supports from underneath the base as pictured. Supports are not needed, even for the 2 magnet cutouts on the backside of the logo along with the 2 magnet cutouts in the 2 leg stand supports, no supports needed whatsoever. I printed everything at 0.2mm layer thickness. I set the primary.stl infill to 10% with the secondary.stl to 100%. The project prints in about 6.5 hours. Please refer to the attached photos for dimensions of everything.

Layer Height: 0.2mm
Initial Layer Height: 0.2mm
Monotonic Top/Bottom Order: ✅
Infill Density: 10% for primary.stl, 100% for secondary.stl
Printing Temp: 200C
Bed Temp: 60C
Print Speed: 50mm/s
Enable Retraction: ✅
Z Hop when retracted: ✅
Z Hop height: 0.8.mm CRUCIAL SETTING FOR LAST LAYER
NO SUPPORTS NEEDED
Build Plate Adhesion Type: Skirt