Double Voronoi Tripod Floor Lamp

This lamp uses two Voronoi cylinders to reduce glare and provide soft mood lighting.

The legs are formed from equal lengths of 15mm copper pipe (standard-sized plumbing tube in the UK) and the height can be varied depending on the leg length. Legs in the example pictures are 1m.

Designed to use 2 core flex, one of the leg 'feet' and the top of the tripod have access holes for the flex, allowing it to run through the inside of a leg without coming into contact with pipe ends.

Uses a standard pendant lamp holder (BC22 or ES27). The light frame and tripod top have a 29mm hole to accept this type of fitting (pictured). You can either use the screw collar on the lamp holder to join these two parts or glue them together.

The shade sits on top of the frame. In low traffic areas it will be OK to rely on gravity alone but you may wish to glue these parts together.

Needs A Large Print Bed
It's designed to be a floor lamp and needs to be big - I make no apologies for this!

The shade is 262mm in diameter and 362mm high. The example in the pic was printed on a Creality CR-10s

DON'T MESS WITH ELECTRICITY UNLESS YOU YOU KNOW WHAT YOU ARE DOING

All files are in their correct print orientation. No supports are required. The quality of the shade will be dependent on your printer's ability to print overhangs and your patience!

There is nothing really special required from print settings but I printing everything except the shade with 4 or 5 walls and top/bottom layers with at least 20% infill for strength.

With the shade, it's really down to your patience and how good you want it to be!

Check all parts for fit before assembling.
Remove any roughness or burrs from the ends of the copper pipes.
Make sure you do not damage the insulation of the flex!!!!
You will need 2 x TripodFoot-Plain prints