One Piece │ Enma │ Katana of Kozuki Oden

Enma is one of the 21 Great Grade swords, and was wielded by Kozuki Oden alongside his other sword, Ame no Habikiri. It is now currently in the possession of Roronoa Zoro as one of his three blades.

• Specifications

Length :
Katana [Sheathed] = 118cm / 46.5 inch
Katana [Unsheathed] = 114cm / 44.9 inch

Width :
Katana blade = 0.6 cm

• Assembly

Connecting the separate parts with super glue is most likely the best and cheapest choice to use, however since the parts are quite thin, the model will be fragile to drop. Its recommended to use a soldering iron to weld the plastic together. Depending on how deep you weld the plastic together, the use of filler may be needed.

The use of wooden dowel's are also a useful way to connect the parts however it would only fit in the handle (unless you find dowel's lower than 0.6cm which can fit in the blade then I may include slot holes if asked). Occasionally swinging the weapon would bend the blade if using super glue to join the blade part together. So this method is mainly used for decorational purposes but can be used for cosplay as well.

• Important notice

Near the bottom of the katana scabbard, I did not include the sageo cord that is meant to be part of the model. This was because it was initially meant to be wrapped using saya cord or any type of red cord but in the future, I may just add it onto the model itself.

• Parts

Assemble from top to bottom, or how you like

Enma Blade
Enma Seppa (Spacer)
Enma Handle
Enma Scabbard

The model is ready to be printed, there's no need to scale it anymore unless you would like it enlarged. Also it is split in order to fit my current printer.

• Printed with FlashForge Creator Pro -

Printed with PLA

Supports recommended
Raft / Brim optional
Infill : 25%