SONIC THE HEDGEHOG LED Wall Lamp

To realize it I started from a reference image for the character in lithophanie via the Canvas tool of FUSION 360 I clipped it, to create the template of the future lithophanie before passing under LuBan 3D, I did the same for the part of the logo, a reference image of a logo a little more Old School than the image of Sonic.

Another particularity I printed my lithophanies horizontally so flat on the tray and the result is at the top, fast and it allowed me to print all the parts on a simple Ender 3 Pro (23.5cm x 23.5cm x 25cm) while the scale of the lithophanies of the Sonic character is 27 cm at the highest so impossible to print for many machines.

Not to mention that vertically even with a printer with enough height, at the level of the tray, few parts would have been in direct contact hence the use of mandatory supports, not to mention the risk of warping and possible deformations on 27 cm high.

The lamp is 42cm long by about 22cm on the highest part.

It can be placed flat or has wall hooks to be easily fixed.

All lithophanies were printed horizontally, with a layer height of 0.20mm and 0.42mm width, 2 walls, 100% fill.

For the box part you can go down to 10% fill 2 walls and layer height 0.25mm pass without worries.

The lamp is wired with a RGBW 5050 LED ribbon purchased on AliExpress.

lien