Pixelated lenses

Good morning, everyone.

I present to you my design of the glasses (Deal with it).

They turned out pretty good, although I accept constructive criticism or improvements to make to it.

I'm going to leave you the files, both with brackets and without, so you can print them as you like.

Both the frame and the white squares are in separate .stls, for those who have a printer with a double extruder.

Any inquiries, you can write to me at my personal mail.

Trovatoariel@gmail.com

Greetings!

Good morning everyone.

I present my glasses design (Deal with it).

They turned out quite well, although I accept constructive criticism or improvements to make.

I am going to leave you the files, both with supports and without, so that you can print them to your liking.

Both the frame and the white squares are in separate .stls, for those who have a dual extruder printer.

Any questions, you can write to my personal email.

Trovatoariel@gmail.com

With a layer height of 0.24 mm is more than enough, if I recommend giving an infill of at least 15% with 3 walls.

I recommend supports on the hinges, that they are properly primed and have adequate strength.

The diameter of the holes, is 3.2 mm, in case the material expands/contracts.

With a layer height of 0.24 mm it is more than enough, I do recommend giving it an infill of at least 15% with 3 walls.

I recommend supports on the hinges, which are properly printed and have adequate strength.

The diameter of the holes is 3.2 mm, in case the material expands/contracts.