POCKET-SIZED FOLDABLE AND HEIGHT-ADJUSTABLE PHONE AND TABLET HOLDER

You can easily put your big phones and tablets on it. It is foldable so you can carry it in your pocket.

This design is easy to print and assembly

The phone in the photos is 6.2 inches.

Balanced designed. Not easily overturned. You can use it at any angle and height you want.

STL files have high quality mesh structure.

Necessary spaces have been made for the speaker, microphone and charging cable. You can charge phones and tablets while they are on the stand. It does not block the sound output of your speaker and does not prevent your microphone from picking up sound.

Excess weight has been removed from the design. It saves filament. You can print it quickly. You will hardly need support.

I really liked this stand, I think you will too.

I printed and tested one by one at home. I'm sure you won't have any problems during installation. If you have a problem don't forget to give feedback and I will help you.

Don't forget to check out my other designs too!

Materials required for assembly:
M4x20 bolts (4 pcs)
M4x10 bolt (1 pcs) (for cylinder)
M4 fiber nuts (4 pcs)
M4 nut (1 pcs) (for cylinder)
M4 washers (2 pcs)

YouTube assembly video is here: https://youtu.be/WdQ8Qu0_IBQ

Cylinder and Piston:
Layer height: 0.2 Recommended (lower value is better quality)
Number of wall lines: 2
Supports: YES
Support Angle: 60
Infill: 20% or higher
Fan: 100%

Star screw head:
Layer height: 0.12 Recommended
Number of wall lines: 3
Supports: NO
Infill: 100%
Fan: 100%

Bed and top swing:
Layer height: 0.2 Recommended (lower value is better quality)
Number of wall lines: 2
Supports: YES
Support Angle: 60
Infill: 20% or higher (The heavier the bed, the better for balance.)
Fan: 100%

Left and right holder:
Layer height: 0.2 Recommended (lower value is better quality)
Number of wall lines: 2
Supports: YES
Support Angle: 80
Infill: 20% or higher
Fan: 100% (for pla)