Samsung Galaxy Tab A7 10.4" (2020) SM-T500 / SM-T505 Wall Mount

Wall mount designed for the 10.4 inch 2020 Samsung Galaxy Tab A7 SM-T500 (standard) and SM-T505 (LTE).
Primarily intended for use as a dashboard with home automation systems such as Home Assistant, Hubitat, ActionTiles etc.

Designed to use a readily available 90 degree USB-C Cable (UGREEN) and hide the cable from view.

A spacer allows the tablet to 'float' away from the wall, while allowing the USB cable to enter a wall box.

Mounting holes are provided for direct attachment to both UK (60mm hole spacing) and US (83.34mm hole spacing) single back boxes with additional mounting holes for screwing directly to a wall if needed.

There is also an extension to the power button, allowing the tablet to be shut down/restarted while in the mount.

WARNING - YOU NEED A BIG PRINT BED!!!!
You will not be able to print this design on an Ender 3 or similar printer.
Minimum bed size requirement is 280mm (without skirt lines). All prints in the images were produced on a Creality Ender 5 plus but they will quite happily fit on a CR-10 or other printer with a 300mm print bed.

CHECK YOUR PRINTABLE AREA BEFORE BUYING - WE WILL NOT PROVIDE REFUNDS IF THIS DESIGN IS TOO BIG FOR YOUR PRINTER - YOU HAVE BEEN WARNED

PERSONAL USE ONLY
Files are provided for your personal use.
Any/all commercial use is prohibited, as is sharing of files purchased.

All files are oriented in their intended placement. Supports are not required anywhere.
Recommended settings for a 0.4mm nozzle:

Spacer and Wall Plate

• Layer Height: 0.28
• Top and Bottom Layers: 4
• Walls/Perimeters: 3
• Infill: 20%

Front Frame

• Layer Height: 0.2mm
• Top and Bottom Layers: 4
• Walls/Perimeters: 3
• Infill: 20%
• Print front face down on a Glass or PEI bed for the very best results. Make sure your bed tramming (levelling) is 100% spot on!

Power Switch

• Layer Height: 0.12mm (you want this as smooth as possible!)
• Top and Bottom Layers: 5
• Walls/Perimeters: 5
• Infill: Doesn't matter - the walls will make it solid.
• This is a small part so you may want to print it on a raft or use a few lines of brim (you will need to clean those off carefully).

Post Processing

Depending on how well your printer and profiles are set up, you may need to trim/sand the wall plate and frame where the power button resides. It obviously needs to travel smoothly and not get stuck.

Marks On Your Tablet

The wall frame WILL create marks on the edge of your tablet. If this bothers you, I would suggest putting some thin tape between the wall plate clips and the edge of the table.