Airsoft RPG-26 Anti Tank Launcher

Airsoft RPG - 26

Uses 40mm grenades including Taginn Shells. You will need to make yourself a sleeve for the shell as the barrel is a little wider. And different 40mm grenade types make it impossible for me to provide the adapter for all the grenades.

It has been tested extensively and works well.

Assembly Instructions, diagrams and Sticker image is provided.
Assembly Video can be found here:
https://www.youtube.com/watch?v=pzz7dpm6yrI

Tools Required:
-Dremel
-Drill
-Drill Bits Set
-Saw
-Flat File
-Various Grit Sanding Paper
-Primer, Paint, Matt Lacquer
-Hex Key Set
-Philips, Flat Screw Driver
-Scissors
-Thread tapping set

Parts Required:
-Part 01: PVC Pipe od.75mm x t.2.6mm L=730mm
LXV uses low noise soil & waste Wavin SiTech+ od.75mm (2.6mm) pipes. But other manufactorer pipes can be used as well.
-Part 02: PVC Pipe od.50mm x t.1.8mm L=300mm
-Part 03: Aluminium Pipe 12mm x 350mm
-Part 04: Aluminium Pipe 8mm x 35mm

Fasteners Required:
Bolt and Nut Set
Spring Set

Added Experimental pipe size versions:

Imperial:

Bigger Pipe - ID 3 inch (76.20mm), OD 3.25 inch (82.55mm)
Smaller Pipe - ID 1.85 (47mm), OD 2 inch (50.80mm)
Aluminium Pipe - OD 0.5 Inch (12.7mm)

Korean Version:

Bigger Pipe VG2 - OD 76mm, ID 66mm
Smaller Pipe VG1 - OD 48mm, ID 44mm
(Same aluminium rods/pipes as original)

Please note that this is a airsoft replica and should be treated as such, no public demonstrations or any other misconduct.

I do not permit resale of either data downloaded or the launcher itself. Please support the creator and if you are making the launcher for someone else purchase another blueprint these kind of projects take a lot of time and resources and I would greatly appreciate this. Thank you.

Printed using ASA