Speed Racer - 2X

Original Design Speed Racer (Gō Mifune)

I wanted to print characters that are 2 times normal size,
Most parts have been redesigned, some reference from
Supernova_6969's Figurine Remixed
https://www.thingiverse.com/thing:2410047

Face: I use Sharpie markers. Use Supports around the lower face. (Flesh)

Helmet -M filled in with Sharpie. I printed the helmet upside down and used supports. (White). I then used the SpeedRacerVisor Pattern to cut clear plastic (clear small plastic cups works very well, but here is clear plastic packaging on lots of things)

Arms: start with Blue then White at Layer 77 then switch to flesh at Layer 99.
Putting on the arms I use a little veg oil on the body holes,
the arms will go in with a bit of pressure and rotating.

Collar: IFlipped 180 and use supports under the edge of the V, afterward the V separates from the other part of the collar for easier assembly. (White)

Hair: I rotated it 130 degrees on Y and used supports. (Black)

Hips: Start with Blue then switch at layer 88 to White.

Legs: Start with Brown(shoes) at layer 44 switch to Red(socks) at layer 50 switch to White (pants)

Neck: I flipped 180 degrees and printed with supports on the edges. (Flesh)

Torso: no supports necessary (Blue)

Hands: no supports necessary (Orange)

G: no supports necessary (Yellow)

Scarf: Use Ribbon or Fabric (Red)

-