Support de tringle à rideau sur volet roulant / Curtain rod holder on roller shutter

Support de tringle à rideau sur volet roulant / Curtain rod holder on roller shutter

https://youtu.be/sdY7B_xtPQo

Curtain rod support suitable for roller shutters with 18 to 23 cm box.

Operates by pressing on the box. Plastics can slide between each other, just add a little rubber on the 2 jaws.

If required, an additional screw on the top can be used to increase pressure. Personally, I haven't needed it.

The 45-degree arms carrying the curtain rod make it easy to open the window.

Suitable for 16 to 20mm curtain rods.

There are files for the right-hand side and others for the left-hand side.

For cranked roller shutter boxes, an offset bottom jaw solves the problem.

Parts can be printed without supports

The parts are marked with a label to avoid mistakes.

Right-side high jaw: code 1D

Right-side arm for 16mm bar: code 2D 16mm

Right-side arm for 19mm bar: code 2D 19mm

Right side arm for 19mm bar: 2D code 20mm

Left side high jaw : code 1G

Left side arm for 16mm bar : code 2G 16mm

Left-side arm for 16mm bar: code 2G 19mm

Left side arm for 16mm bar: code 2G 20mm

Standard lower jaw: code 3 Std

Right-side low fine jaw: code 3 DF

Low fine jaw, left side : code 3 GF

Clamping screw : code 4

Pressure screw (if required) : code 5

PLA

hauteur Couche / Layer Height: 0.20mm

Paroi / Wall Thchness: >= 1.2 mm

Infill Dentisity: >=30%

No support