If you're anything like us, your burgeoning bot collections may have be sitting on levels and levels of the CyberBase System tiles. The slight worry at times though, is that the ones on the top level are simply standing on a raised platform which increases the danger of them falling straight off the edges.
Thus, here's introducing the Guardrails addon set and here's a look at the various parts of the set.
A couple of things to note:
The different lengths of the rail are such that the longer 15cm will fit end to end through the posts which are affixed on a CBS base tile. The shorter 12cm rail will only peg in without going through the post to the end - this is required to form the corners.
If you would like a longer rail to span across the front of your display, the rail piece can be scaled in one direction to any length you prefer. Or if the desired length does not fit on your printer, the provided Rail_clip can be used to join shorter rail segments also.
Finally after all the Posts and Rails have been assembled, the 5mm_Peg piece can optionally be used to plug up any of the posts' side holes and also provide a standard 5mm port for accessories and such to be pegged onto.
===
Haven't had the chance to grab photos of this set in action yet, but like the rest of the series, the pieces should fit together quite modularly to provide some fall protection for all your prized collections. =)
===
This model is not to be uploaded or sold in any form and is intended for personal use only.
Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)
Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog