Victorian Tower Book Stand 3D print model

This is my Victorian Tower design for your bookshelf! :)
The model is made by me.
Modelling time 4 hours.
NO SUPPORT! JUST PRINT!
You can organize your books with that Tower.
There is two towers, two output part, one input part is exist.
The tower consist with three parts. You can print it as one object or print split. All of them is inclueded the project.
This book stand designed for 8 books but you can print one more input and one more output to make it bigger.

CREALITY CR-10 PRINT SETTINGS

Settings for one Top Tower
Print with 0.15mm ( 150 micron )
No Support
%10 infill
60 Degrees for Bed Heat
200 Degrees for Nozzle Heat
Printing time is 11 Hours.

Print Settings for one Output
Print with 0.2mm ( 200 micron )
%20 infill
No Support
60 Degrees Bed Heat
200 Degrees Nozzle Heat
Printing time is 2 hours.

Print Settings for Input
Print with 0.2mm ( 200 micron )
%20 infill
No Support
60 Degrees Bed Heat
200 Degrees Nozzle Heat
Printing time is 2 hours.

Print Settings for bottom of Tower
Print with 0.2mm ( 200 micron )
%20 infill
No Support
60 Degrees Bed Heat
200 Degrees Nozzle Heat
Printing time is 3 hours.

Print Settings for middle of Tower
Print with 0.2mm ( 200 micron )
%20 infill
No Support
60 Degrees Bed Heat
200 Degrees Nozzle Heat
Printing time is 4 hours.

You will print the whole model is in just two days :)

No Need for sandpaper or any finishing techniques if you use 0.1mm layer height.
Hope you like guys!

If you have any question about my designs or anything, please don't hesitate to write me a message!
You can also send me a message for your bulk purchase to.
See you on next projects!