Betrayal at the House on the Hill Tile Holders Set 3D print model

Betrayal at the House on the Hill finally got some much needed revised character cards, but what about those annoying map tiles that warp and move around?

Here is your solution!

These tile holders allow you to connect all of your map tiles together, quickly and easily, while not taking away from the look of the game.

They also have a little bit of depth so warped tiles are no issue now!

*** BUYERS DO NOT HAVE PERMISSION TO USE THIS FOR COMMERCIAL PURPOSES ***

** Recommended Print Settings **

You can print these at a high layer height, I print at 0.32mm which is as high as you can go with a 0.4mm nozzle.

If you're used to printing at lower layer heights like 0.2mm, you may want to bump the temperature by 5-10 degrees.

You can turn your part fan off for better layer adhesion and less stringing.

️ *Legal Stuff *

This listing is a fan-made design intended to be used with the game Betrayal at the House on the Hill and its associated expansions. I am in no way affiliated or licensed by any of the publishers associated with the game. To the best of my knowledge, these items do not compete with any official accessories made for this game. These items are intended solely to increase the enjoyment of playing the game.

This is a Deluxe Board Gamer original design! This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivs 3.0 Unported License. To view a copy of this license, visit http://creativecommons.org/licenses/by-nc-nd/3.0/ or send a letter to Creative Commons, PO Bo